Red Dot sight
Model No: RDP-II Model: RDP-II
Field of View: 14m@100m
Windage/ Elevation Adjustment: Up/R:20cm@100m
Dot Size: 3MOA
Sight Window: 22mm x16mm
Parallax Free: approx.50yards
Red Dot sight
Detailed Product Description
Compact tubeless design and small size.
Low weight without sacrificing performance.
Sophisticated optical system with high-quality imaging.
Suitable for pistols, short barrel and large caliber guns. Easy mounting with you
own optional mount adapter
Large field of view due to its low magnification
Parallax is free at 50 yards.
Low power consumption for long battery life
Automatically adjust the brightness of the aiming dot to varying light levels in
RDP- II Mini Sight is powered by one 3V lithium battery (CR2032 or equivalent). Insert
the battery cavity on the underside of the housing so that the battery label
identifying the positive pole is visible. For battery replacement, take out the
exhausted battery by placing the Allen key in the notch located on the right-hand
side as see from the bottom.
The device does not contain a separate ON/OFF switch. To operate the electronic circuit
in the power-saving mode, attach the cover. You may also store the device
in a lightproof box to achieve the same power-saving effect thus allowing operation
over a longer period.
Mounting the sight requires a separate mount adapter for your respective gun. The
underside of the sight housing contains flat bores for the accommodation of alignment
pins providing defined position. Using the hexagon socket-head screws and
the Allen key provided fasten the sight on the mount adapter. Then, tighten the
mount adapter on the gun.
ELEVATION AND WINDAGE ADJUSTMENT
The sight contains separate controls for elevation and windage adjustment. To adjust
the sight, turn the slotted screws using the provided adjusting wrench with
attached scale and the screwdriver. Before every adjustment of elevation or windage,
turn the thrust and clamp screws on the rear side of the sight to make sure
to loosen the lock of the adjustment mechanism to avoid damage to it.
Adjust the point of impact using the provided scale disk with integrated screwdriver.
Put the scale disk onto the elevation or windage adjustment screws. Use any
edge on the sight as the reference line for the adjustment. The scale disk allows
defined elevation and windage adjustment in both senses of rotation. Turn the
adjustment screw clockwise results in downward or leftward shift of the aiming
dot. After that, fasten the clamp screws.
SCOPE OF DELIVERY
2 countersunk screws M3x8 with hexagon socket head for installing the sight on the
1 Allen key for tightening the fastening screws
1 adjusting wrench with scale disk specific for the sight
1 protective cap
1 Lithium battery 3 V, CR 2032
||100%T/T in advance
|Delivery Lead Time:
||two weeks after our receipt of the full payment